BM Chemiluminescence Western Blotting Kit (Mouse/Rabbit) 11520709001

Detection of membrane-bound molecules is carried out by a variety of procedures. In protein analysis, the molecules of interest are usually detected with specific first antibodies, enzyme-labeled secondary reagents (antibody- or streptavidin-conjugates) and a suitable chromogenic substrate. These detection systems, however, may be time-consuming or lacking sensitivity. In addition, colors tend to fade with time and exposure to light.
To overcome these problems, attempts have been made to use chemiluminescence for fast and sensitive detection of enzyme conjugates on blots. The BM Chemiluminescence Western Blotting System is designed around peroxidase-labeled secondary antibodies and the substrate luminol. In the presence of hydrogen peroxide (H2O2), horseradish peroxidase (POD, HRP) catalyzes the oxidation of diacylhydrazides such as luminol. An activated intermediate reaction product is formed, which decays to the ground state by emitting light. Strong enhancement of the light emission is produced by 4-iodophenol. This acts as a radical transmitter between the formed oxygen radical and luminol.
BM Chemiluminescence Western Blotting Kit (Mouse/Rabbit) is used to detect proteins with peroxidase-labeled secondary antibodies and the chemiluminescent substrate luminol on western blots. The chemiluminescence system is specifically suited for western and dot blot applications where high sensitivity is required.<<

High sensitivity: Detection with this kit is as sensitive as radioactive detection.

Fast: Short exposure times ranging from a few seconds to one hour for obtaining highly sensitive results.

Nonradioactive: Safe and produces no radioactive waste.

Stable hard-copy results on film: No fading occurs during storage.

Quantifiable results: Bands or dots on films can be quantified with a densitometer.

Economically: Detection of antigen with low amounts of antibody or low affinity antibody.

Packaging
1 kit containing 4 components.
Principle
Each lot is function tested on a dot blot.
The BM Chemiluminescence Western blotting System is designed for peroxidase-labeled secondary antibodies and the substrate luminol. In the presence of hydrogen peroxide (H202), horseradish peroxidase (HRP) catalyzes the oxidation of diacylhydrazides, such as luminol. An activated intermediate reaction product is formed, which decays to the ground state by emitting light. Strong enhancement of the light emission is produced by 4-iodophenol. This acts as a radical transmitter between the formed oxygen radical and luminol.
Preparation Note
Working solution: Preparation of additional reagents and solutions
The table inside the PI describes the preparation of working solutions. For reproducible results equilibrate all solutions to 20 to 25 °C before use.
Storage conditions (working solution):

• 1% Blocking solution: -15 to -25 °C
• 0.5% Blocking solution: -15 to -25 °C
• POD-labeled secondary antibody stock solution: 12 month at 2 to 8 °C
• POD-labeled secondary antibody working solution: prepare always fresh
• Detection solution: 1 week at 2 to 8 °C

Reconstitution
Reconstitute lyophilizate in 100 µl double-dist. water. This solution is stable for 12 months at 2 to 8 °C.
For life science research only. Not for use in diagnostic procedures.

Quality Level	100,
Торговая марка	Roche
shipped in	wet ice
storage temp.	2-8°C

pictograms	GHS07
signalword	Warning
hcodes	H317
pcodes	P261 - P272 - P280 - P333 + P313 - P362 + P364 - P501
RIDADR	NONH for all modes of transport
WGK Germany	WGK 2
Flash Point F	does not flash
Flash Point C	does not flash